Estimado After:
Yo tengo un ADSL Modem-Router marca "2wire" conectado a un Switch. Compre un Switch Inteligente bastante caro y en una empresa de unos amigos observe que tenìan el mismo Modem-Router mio en Modo Bridge y a este le habìan conectado un Router(Linksys). Les funcionaba perfectamente.
Lògicamente, el firewall del Modem-Router queda totalmente deshabilitado cuando pasa a Modo Bridge; por lo tanto estaban usando el Firewall del Router nuevo.
Con lo que observe,`pense que lo mejor era tener el Modem-Router en Modo Bridge y a este conectarle mi nuevo switch inteligente.
Al final no lo hice.
Cuando me contacte con el fabricante de los Modem-Router marca 2wire y explicarles lo que querìa hacer me enviaron lo que a continuaciòn podras leer:
En los manuales que ellos suministran no aparece la modalidad de "Modo Bridge", y es una modalidad, que al adquirirla, se pierde el servicio de soporte que normalmente viene con la compra de un Modem-Router.
Saludos y piensa bien lo que quieres hacer.
TEXTO EN INGLES:
Thank you for contacting 2Wire Customer Support. The following is intended to answer your inquiry:
The mode that your friend has their 2Wire gateway in is called bridge mode, I have included the instructions for placing the gateway into bridge mode, but bear in mind that you would then need a device on your network to handle the authentication session.
These directions for enabling bridging mode are to only be used by customers with the prior knowledge that any configuration issues or problems that arise during the use of bridging mode are not supported. 2Wire Technical Support can only support a HomePortal when it is fully functioning as a router.
By disabling routing e.g. using “Bridge Mode” you will have deliberately turned off all firewall functionality.
1. Clear the HomePortal to Factory State –can be accomplished two ways
a. MDC
i. Go to
http://gateway.2wire.net
ii. Click on Resets
iii. Click on Reset to Factory State
iv. Click Continue
b. Press Hardware Reset button with paperclip
i. Unbend a paperclip
ii. Insert paperclip into recess for Hardware Reset button (outlined with Red circle) on back of HomePortal.
iii. Hold paper clip in for ten (10) full seconds
2. Go to
http://gateway.2wire.net/mdc and click on Configure under Broadband Link
3. Enter VPI 0 and VCI 35
4. Click on Disable PVC Search
5. Set Connection Type to Direct IP
6. Click Submit/Save
7. Go to
http://gateway.2wire.net/mdc
a. Click on Configure Services
b. Uncheck Enable Routing
c. Click Submit
When the Homeportal is in Bridge Mode it no longer performs any functions such as managing your PPPoE connection. If your Internet service provider uses this type of authentication then you will need to configure the 3rd party router to manage that for you.
If this response has not answered your question or resolved your issue you may visit our support Website at
http://support.2wire.com or reply to this email.
Thank You,
Eric D.
2Wire Customer Support